On this page
Key takeaways
- Treat any full alarm (a loud, repeating pattern of beeps) as real. Open windows, turn off gas appliances if safe, get outside and call 0800 111 999.
- A single short chirp roughly once a minute usually means the battery is low or loose.
- A chirp about every 30 seconds that carries on after new batteries usually means the alarm has reached end of life and no longer detects CO. Replace it.
- Patterns vary by manufacturer, so check the label or instructions on your model once the immediate situation is safe.
- After any genuine alarm, do not use the appliance again until a Gas Safe registered engineer has checked it.
A carbon monoxide alarm beeping can mean three very different things: a low battery, an alarm that has reached the end of its life, or carbon monoxide in the air. A full alarm is loud, repeated and urgent, usually several beeps in a row with a red light, and it means get everyone outside and call the National Gas Emergency Service on 0800 111 999. A single chirp every 30 to 60 seconds is almost always the alarm asking for attention, not a gas emergency.
The trouble is that sounds differ between brands, and a frightened person at 3am is not in the best state to read a manual. This guide sets out how to tell the sounds apart, what to do first, and what happens afterwards.
Is it a real alarm or a chirp? A 10-second test
Listen for the pattern, not the volume alone. A real carbon monoxide alarm is designed to wake you: a loud burst of several beeps, a short pause, then the same burst again, over and over. A chirp is a single short sound, separated by a long gap of half a minute or more.
If you are not sure which you are hearing, act as if it is a real alarm. Getting fresh air costs you a few minutes. Ignoring a genuine warning can cost far more, because carbon monoxide has no smell, taste or colour. Our guide to carbon monoxide poisoning symptoms explains why it is so easily missed.
What the different CO alarm sounds mean
Below are real examples from two common UK manufacturers. They show the general pattern most alarms follow, but your model may differ, so treat this as a guide rather than a rule.
| What you hear and see | Typical meaning | What to do |
|---|---|---|
| Repeated bursts of beeps (FireAngel: 4 chirps with a red flash every second) | Dangerous level of carbon monoxide detected | Emergency steps below, straight away |
| Two chirps with a yellow flash every 4 seconds (FireAngel “ventilate” warning) | Low-level CO building up | Open windows, stop using gas appliances, call 0800 111 999 for advice |
| Single chirp about once a minute, often with a yellow flash | Low battery | Replace or refit the battery with the type stated on the alarm |
| Chirp about every 30 seconds that continues after new batteries (Kidde) | End of life, the sensor has expired | Replace the whole alarm |
| Red light flashing with no sound (FireAngel “alarm memory”) | The alarm detected CO while you were out | Do not ignore it. Ventilate and get the appliances checked |
Sources: the FireAngel CO alarm icon identifier guide and Kidde UK’s end of life warning FAQ.
Low battery chirp
Kidde lists a loose battery, the wrong battery type and a low battery as common causes of chirping. Take the alarm down, check the battery is the type printed on the label and that it sits firmly, then fit a fresh one and press the test button. Some sealed alarms have a battery that lasts the life of the unit and cannot be changed; on those, a low battery warning means replacing the alarm.
End of life chirp
CO sensors wear out. Kidde says its alarms signal end of life seven or ten years after they were first powered up, depending on the model, and that the chirp will not stop when you change the batteries. In that mode the alarm no longer detects carbon monoxide, so you are effectively unprotected. Most alarms also have a “replace by” date printed on the back or side. If yours is past that date, replace it now, whether it is chirping or not.
Fault warnings
Some alarms have a separate fault signal, often a different chirp pattern or an error message on a digital display. The meaning varies between brands, so check the manufacturer’s instructions. A faulty alarm cannot be relied on and should be replaced.
What to do if your carbon monoxide alarm goes off
If the alarm is sounding a full alarm pattern, follow these steps in order. They match the advice given by the gas networks, including Northern Gas Networks’ carbon monoxide advice.
- Open doors and windows as you go, to let fresh air in.
- Turn off gas appliances such as the boiler, gas fire or cooker, but only if you can do it quickly and safely. If it is safe, turn off the gas at the emergency control valve by the meter.
- Get everyone outside into fresh air, including pets. Do not stop to search for the source.
- Call the National Gas Emergency Service on 0800 111 999. The line is free and open 24 hours a day. They will send someone to make the property safe.
- Get medical help if anyone feels unwell. Headache, dizziness, nausea, breathlessness or confusion are warning signs. Call 999 if someone has collapsed or is seriously ill, and tell the medics you suspect carbon monoxide.
- Stay out until the emergency service tells you it is safe to go back in.
Do not press the silence button and go back to bed. Even if the alarm stops, the source has not gone away.
Can a carbon monoxide alarm give a false alarm?
Genuine false alarms are less common than people assume, and you should never decide an alarm is false on your own. That said, some things can set an alarm off or confuse it:
- Exhaust fumes drifting in from a car left running in an attached garage or near an open window.
- A solid fuel stove, open fire or barbecue used nearby, which produce carbon monoxide just as faulty gas appliances do.
- Aerosols, cleaning products or paint solvents sprayed close to the sensor, which some manufacturers warn can affect readings.
- Very high humidity, such as an alarm mounted in a bathroom or directly above a kettle.
- An alarm that is past its replacement date.
Even when one of these explains the alarm, the right response is the same: ventilate, get out and call 0800 111 999. Let the emergency engineer confirm whether there is CO present. A “false” alarm can easily be a real low-level leak that happened to coincide with something else.
What happens after the alarm
The emergency service engineer will check for gas and carbon monoxide, and may isolate an appliance or the whole supply. If an appliance is found unsafe, it may be labelled under the Gas Industry Unsafe Situations Procedure, which our article on At Risk and Immediately Dangerous warning notices explains.
The emergency service makes things safe but does not repair your appliances. You will need a Gas Safe registered engineer to find the cause, which is often a blocked or damaged flue, poor combustion, a cracked heat exchanger, or not enough ventilation for an open-flued appliance. Do not switch the appliance back on until it has been checked and repaired. Gasmaster offers a same-day emergency call-out for situations like this across Stoke-on-Trent and the surrounding areas.
Keeping your CO alarm working
An alarm only protects you if it works and is in the right place. A few simple habits make a big difference:
- Press the test button once a month. It checks the sounder and electronics; it does not release real gas.
- Write the replacement date somewhere obvious, or set a reminder on your phone.
- Choose an alarm that meets BS EN 50291, the European standard for domestic CO alarms, and look for the mark on the packaging.
- Fit one in every room with a fuel-burning appliance, and follow the manufacturer’s guidance on height and distance from the appliance.
- Do not paint over it, cover it, or put it inside a cupboard.
Our guide to carbon monoxide alarms and your boiler covers placement in more detail. The alarm is a backup, though, not a replacement for maintenance. An annual boiler service checks combustion and the flue so problems are caught before they produce carbon monoxide.
Next steps
If your alarm is chirping, check the battery, then the replacement date, and replace the alarm if in doubt. If it has gone into full alarm, get out and call 0800 111 999 first. Once the property has been made safe, contact Gasmaster to book a Gas Safe registered engineer to inspect the appliance, find the cause and put it right.
[googlesitekit-end-of-content]
Frequently asked questions
Why is my CO alarm chirping when the batteries are new?
If fresh batteries of the correct type are fitted properly and the chirp continues, the alarm has most likely reached the end of its working life. Kidde, for example, says its end of life chirp sounds about every 30 seconds and will not stop with new batteries. Check the replace-by date on the back and buy a new alarm.
Can I take the battery out to stop the beeping?
Only if you are certain it is a low battery or end of life chirp, and only if you replace the battery or the whole alarm straight away. Leaving a room with a gas, oil or solid fuel appliance unprotected, even overnight, removes your only warning of carbon monoxide. Never remove the battery to silence a full alarm.
How long do carbon monoxide alarms last?
Most domestic CO alarms are designed to last between seven and ten years, depending on the make and model. The sensor slowly loses its ability to detect gas, so the alarm is built to warn you when it is time. Check the date printed on the unit, and replace it on time even if it seems to work.
Should I call 999 or 0800 111 999 for carbon monoxide?
Call the National Gas Emergency Service on 0800 111 999 to report suspected carbon monoxide from a gas appliance, so they can make the property safe. If anyone is unconscious, has collapsed or is seriously unwell, call 999 for an ambulance first. For milder symptoms, contact your GP or NHS 111 and mention carbon monoxide.
My alarm went off then stopped. Is it safe now?
Not necessarily. Opening windows can bring the level down enough to stop the alarm while the faulty appliance keeps producing carbon monoxide. Keep the appliance switched off, keep the area ventilated and call 0800 111 999 for advice. Have a Gas Safe registered engineer check the appliance before you use it again.
Related services




